Configuring the conference system
60
–“1” = low
–“12” = very high
The selected volume level is displayed between the two buttons.
̈ Click “Save settings”.
The setting is saved. The loudspeaker volume is set to the selected
level.
Setting the number of interpretation channels
̈ In the main navigation, click “Conference management”.
The “General Conference Settings” overview screen appears.
̈ In the “Number of interpretation channels” box, click the desired option
button.
You can offer “0”, “2”, “4”, “8”, “12” or “16” interpretation channels.
̈ Click “Save settings”.
The setting is saved. The maximum number of interpretation channels
is set (see also
“Using the interpretation system” on page 79). If
necessary, the maximum number of simultaneously active
microphones (speaker limit) will be reduced (see
page 57). Values that
can no longer be selected will be displayed in red in the “Maximum
number of active microphones” box.
The volume of the conference units’ loudspeakers can also be set
via the WiCOS
CV or WiCOS C chairman unit (see page 41).