Filter
Top Products
38 HP Jornada 700 Series Handheld PC
Connecting by USB port
Using the cradle (optional on the HP Jornada 710) you can
also make a USB connection to your desktop PC. A
standard USB A-to-B cable (not included) is required in
order to make a USB connection.
To connect via USB port using the docking cradle
1. Connect the flat USB "A" connector to an available USB
port on your desktop PC (cable not included).
2. Slide the port cover on the back of the docking cradle to
the left to expose the USB port.
3. Insert the square USB "B" connector into the USB port
on the back of the docking cradle
4. Turn off your HP Jornada and disconnect any cables
(telephone cable, ac adapter, sync cable, etc.) from your
HP Jornada.
5. Connect the ac adapter to the dc jack on the back of the
docking cradle, and then plug in the power cord.
6. Align your HP Jornada in the docking cradle, and push
down firmly until the HP Jornada snaps into place.
Your HP Jornada should start automatically and establish a
connection to the desktop computer. To remove your HP Jornada
from the docking cradle, push the release button on the cradle,
and carefully lift your HP Jornada from the cradle.
If you are traveling without your docking cradle or you need to
synchronize files with your home computer while the docking
cradle is connected to your office PC, you can connect your HP
Jornada directly to a desktop PC using only the serial sync cable.
(See Connecting by serial port earlier in this chapter.)
You can also connect and synchronize by infrared. For more
information, see the Connecting by infrared section in this
chapter.
Establishing a partnership
After you set up Microsoft ActiveSync on your desktop PC, you
are prompted to establish a partnership between your desktop PC