Filter
Top Products
Chapter 7 Working with CCR Trees 73
CallPilot 150 Telephone Administration Guide
About transfers to external numbers
When CallPilot transfers a call using a CCR external transfer, it uses two lines. An incoming line
connects the caller to the CCR Tree and an outgoing line transfers the caller to the external
telephone number. Both lines are used while the caller connects to the external telephone number.
To optimize the use of external lines, the incoming line can be used to make the external transfer.
This type of transfer is called a Link transfer.
Not all phone lines allow Link transfers. Ask your telephone service provider if your lines support
Link transfers before you program CallPilot to use Link transfers.
To perform a Link transfer for a CCR external transfer you must press £ before the telephone
number. For example, for the telephone number:
£fififi⁄¤‹›
fififi⁄¤‹› is the telephone number dialed
For information on preventing unauthorized calls using outdial, refer to “Outdial route” on page 21.
To add a Transfer to an external number
16 Press ® to end the session.
1 Press ≤·°‹.
Enter the System Administrator Mailbox number and password,
and then press OK
.
2 Press OTHR
.
3 Press CCR
.
4 Press ADMIN
.
5 Enter the number of the CCR Tree you want to add a Transfer node
to and press OK
.
6 Press CHNG
,
7 Enter the Path number and press OK
.
For example, to create a Transfer node on the second level of a CCR
Tree, enter ⁄⁄. The first 1 is the path of the first level Menu
node. The second digit is the path where you want to create the
Transfer node.
CCR Admin
ADMIN
Log:
QUIT RETRY OK
Admin
MBOX AA OTHR
Admin
GLIST CCR
CCR Admin
ADMIN
CCR tree:
RETRY OK
Tree: x
CHNG
QUIT
Path:
RETRY END OK