Filter
Top Products
Chapter 10 Dialing Translation 111
CallPilot 150 Telephone Administration Guide
Changing a Dialing
Translation Table entry
After you build a Dialing Translation Table you can change the Output value of an entry at any
time.
You cannot change the Input value of an entry. You must delete the entry and create a new entry
with new Input and Output values. Refer to “Deleting a Dialing Translation Table entry” on page
112.
To change an entry in the Dialing Translation Table
1 Press ≤·°‹.
Enter the System Administrator Mailbox number and password,
and then press OK
.
2 Press
°°
.
This option does not appear as a display button option.
3 Press TABLE
.
4 Press CHNG
.
5 Press OTHR
.
Inval* outval* is an example of a Table entry.
6 Press CHNG
.
7 Enter a new output value up to 15 digits.
8 Press OK
to accept the output value
or
press RETRY
to enter a new output value.
9 Press ® to end the session.
Log:
QUIT RETRY OK
Admin
MBOX AA OTHR
Dialing
PARM TABLE NEXT
Dial Table
ADD CHNG QUIT
Inval* outval*
NEXT OTHR
Inval* outval*
CHNG DEL FIND
Out:
RETRY OK
Out: xxx
RETRY OK