Filter
Top Products
Chapter 5 Setting up the Automated Attendant 51
CallPilot 150 Telephone Administration Guide
Assigning the number of rings before CallPilot answers
You can assign the system to answer incoming calls after a specified number of rings. The number
of rings ranges from 0 to 12. If you leave the number of rings at zero, the system answers
immediately.
For lines equipped with Calling Line Identification (CLID), you must set the number of rings to
two or more if you use analog lines. CLID is not provided until just prior to the second ring, so
assigning the number of rings to 0 or 1 prevents CLID from being relayed. You do not have to set
the number of rings to two or more for CLID if you use BRI/PRI lines. For more information about
the type of lines you use contact your Norstar administrator.
Without CLID, personalized greetings, CLID Routing Table and other features related to CLID do
not work.
To assign or change the number of rings
1 Press ≤·°‹.
Enter the System Administrator Mailbox number and password,
and then press OK
.
2 Press AA
.
3 Press LINES
.
4 Enter the line number and press OK
.
5 Press TABLE
.
6 Press RINGS
.
7 Press CHNG
.
8 Enter a number of rings from 0 to 12 and press OK
.
Enter 2 rings or greater if your company subscribes to Caller ID.
9 You can use the NEXT
and CHNG buttons to view the lines and change
the number of rings.
You can press • to return to step 4 and select a line number
without having to go through the entire list.
10 Press ® to end the session.
Log:
QUIT RETRY OK
Admin
MBOX AA OTHR
Auto Atdt Admin
GRTG TABLE LINES
Line number:
RETRY OK
Line:1 Ans:Y
CHNG TABLE NEXT
Line:1 TABLE:1
CHNG RINGS NEXT
Line:1 Rings:0
CHNG ANS NEXT
No of rings:
RETRY OK
Line:1 Rings:X
CHNG ANS NEXT