Filter
Top Products
Off-premise Message Notification 71
P0908524 Issue 01 Enterprise Edge Voice Messaging Reference Guide
7. Enter the destination pager number and press
OK
or
£
.
8. Press
OK
or
£
to accept the destination pager number.
The <x> represents the pager number. Press
ADD
or
¤
to add special characters. If the paging service
requires additional answer or setup time, add pause
characters to the beginning of the pager message. For
information, refer to Adding special characters to the
destination number on page 58. After you add special
characters, press
OK
or
£
to accept the destination
number.
9. Press
NEXT
or
£
to accept the default pager message
(represented by the xxxx). The default pager message
sent by Enterprise Edge Voice Messaging is the
Enterprise Edge Voice Messaging extension. This is
the sequence of digits sent after the pager service is
dialed (to notify you of who is paging you). Press
CHNG
or
⁄
to change the pager message.
Note: There is a combined limit of 29 characters for
the pager phone number and the pager
message.
10. You can choose to be notified of all new messages or
urgent messages only. Press
OK
or
£
to accept the
default message type new. This means you are notified
whenever you receive a new message. Press
CHNG
or
⁄
to change the message type to urgent. Changing
the message type to urgent means you are notified
only when you receive an urgent message.
11. Press ƒ to end the session.
Pager:
RETRY OK
<x>
ADD OK
Show:<xxxx>
CHNG NEXT
Msg type: new
CHNG OK
Msg notify
ADMIN SELECT