Filter
Top Products
CHAPTER 3 SYSTEM DATA PROGRAMMING
ISDN Feature Programming
NEAX2000 IVS
2
ISDN System Manual
ND-70919 (E), Issue 1.0
Page 85
MEGACOM
®
Access
[North America Only]
In addition to the programming of Direct Outward Dialing, assign WATS line to the required trunk
route, as shown below:
DESCRIPTION DATA
Assign the Trunk Restriction Class to each
station.
•
(1)
(2)
YY=01 Trunk Restriction Class
X-XXXXXXXX: Station No.
XZ
X: 1 -8: Trunk Restriction Class in Day
mode
Z: 1 -8: Trunk Restriction Class in
Night mode
1: Unrestricted (RCA)
2: Non-Restricted 1 (RCB)
3: Non-Restricted 2 (RCC)
4: Semi-Restricted 1 (RCD)
5: Semi-Restricted 2 (RCE)
6: Restricted 1 (RCF)
7: Restricted 2 (RCG)
8: Fully-Restricted (RCH)
Set the outgoing/incoming Trunk Route
Restriction data by Trunk Restriction
Classes (RCA-RCH).
•
•
(1)
(2)
YY=51-58 Outgoing Trunk Restriction
YY=61-68 Incoming Trunk Restriction
00-63: Trunk Route No.
0 : Restricted
1 : Allowed
NOTE: If Call-By-Call Service Selection is required, see Page 91 for additional
programming.
DESCRIPTION DATA
Assign a WATS line to the required trunk
route.
•
(1)
(2)
YY=00
00-63: Trunk Route No.
02: WATS line
START
CM12
END
START
CM35
END