Filter
Top Products
CHAPTER 3 SYSTEM DATA PROGRAMMING
ISDN Terminal Data Programming
NEAX2000 IVS
2
ISDN System Manual
ND-70919 (E), Issue 1.0
Page 105
Point-to-Multipoint Connection
DESCRIPTION DATA
Assign the point to multipoint connection
as the Layer 2 data link.
•
(1)
(2)
YY=01
XX Z
XX: 00-15: ICH No.
Z : 0-7: ISDN Line No. of ICH card
1 : Point-to-Multipoint Connection
Specify the passive bus. •
(1)
(2)
YY=03
XX Z
XX: 00-15: ICH No.
Z : 0-7: ISDN Line No. of ICH card
0 : Extended Passive Bus
1 : Short Passive Bus
Assign an ISDN Terminal Multipoint
station number to the ISDN Line station
number.
The numbers assigned in this command
are station numbers that are to be
programmed in the BRI terminal. CM12
YY=12 will use the station assignment
from CM10.
(1)
(2)
XXXXXXXX Z
XXXXXXXX: ISDN Line Station No.
assigned by CM10
Z: 0-7: ISDN Multipoint No.
X-XXXXXXXX: ISDN Terminal
Multipoint Station No.
400407
410417
ILC
• Short Passive Bus
• Extended Passive Bus
MDF
ISDN Terminal
ISDN Terminal
301
300
MDF
ILC
PBX
Max. 1310 ft. (400 m)
Max. 164 ft. (50 m)
Max. 491 ft. (150 m)
START
CMAC
END
CM1B
INITIAL
INITIAL
,