Filter
Top Products
NEAX2000 IVS
2
ISDN System Manual
Page 118 ND-70919 (E), Issue 1.0
CHAPTER 3 SYSTEM DATA PROGRAMMING
Event Based CCIS Programming
BRI Trunk Programming
DESCRIPTION DATA
Assign an AP number to the BRT card.
The AP number must match the SENS
switch setting on the BRT card.
•
(1)
(2)
Y=0
04-15, 20-31: AP No.
10: BRT card
Assign the ISDN Protocol Type for DCH
circuit on the BRT card.
•
(1)
(2)
YY=06
04-15, 20-31: AP No. of BRT assigned
by CM05
ISDN Protocol Type
17 : Australia
18 : New Zealand
20 : AT&T (#4, #5 ESS)
21 : NTI (DMS 100, 250)
22 : Australia ETSI
24 : ETSI Standard
(Brazil, Columbia, Indonesia)
25 : ITU-T Standard (Thailand)
27 : USA NI-1
28 : USA NI-2
63 : Not used
Assign ISDN trunk number to each
Channel number of BRT.
NOTE: Be sure to assign the trunk
numbers to all circuits (00-03) of
the 2BRTC card, even if only one
PCM digital line is accommodated
to the card.
Set make-busy to the unused
trunk numbers by CME5 Y=1, 2nd
data=0.
•
(1)
(2)
YY=02
XX ZZ
XX: AP No. assigned by CM05
ZZ: Channel No. (00/01: BRTA)
(00-03: 2BRTC)
D000-D255: Trunk No.
Trunk No. already
assigned by CM10 cannot
be used.
Assign trunk route to each ISDN trunk
used for Voice channel (B channel).
NOTE: BRT route must be separated
from analog trunk routes.
•
(1)
(2)
YY=00
000-255: Trunk No. assigned by CM07
YY=01
00-63: Trunk Route
START
CM05
CMAA
CM07
CM30
A
INITIAL
DTI INITIAL
INITIAL