Filter
Top Products
NEAX2000 IVS
2
ISDN System Manual
Page 78 ND-70919 (E), Issue 1.0
CHAPTER 3 SYSTEM DATA PROGRAMMING
ISDN-BRI Programming
DESCRIPTION DATA
NOTE 1: This data should be assigned to
the B channel trunk route. For
D channel trunk route, no data
setting is required.
NOTE 2: This data should be assigned to
both B channel trunk route and
D channel trunk route.
•
(1)
(2)
YY=19
00-63: B channel Trunk Route No.
0-3 : Programmable PAD
(See CM42)
4-7 : Fixed PAD
NOTE 1
NOTE: For details of PAD data, refer to
Command Manual.
•
(1)
(2)
YY=28 Outgoing Trunk Queuing
00-63: B channel Trunk Route No.
0: Restricted
NOTE 1
•
(1)
(2)
YY=39 Trunk release by detection of
reversal of tip and ring
00-63: B channel Trunk Route No.
1 : To release
NOTE 1
•
(1)
(2)
YY=90 Assignment of BRT route for
ISDN
00-63: B channel/D channel Trunk
Route No.
2: ISDN-Basic Rate Interface
NOTE 2
Specify the method of Layer 1 activation. •
(1)
(2)
YYY=144
00-63: B channel/D channel Trunk
Route No.
0 : Activated by call event
1 : Always activated
Assign ISDN Local Office Code. •
(1)
(2)
YY=05
00-14: Local Office Table No. assigned
by CM30 YY=34
X....X
(Max. 12 digits)
Assign Service Profile ID (SPID) to each B
channel number.
[North America Only]
•
(1)
(2)
YY=30
XX Z
XX: 04-15: AP No. assigned by CM05
Z : 0-3: B ch No.
XXXX ZZZZ
XXXX: ISDN Subscriber No.
ZZZZ : SPID
CM35
C
CM50
CMAC
D