Filter
Top Products
NEAX2000 IVS
2
ISDN System Manual
Page 80 ND-70919 (E), Issue 1.0
CHAPTER 3 SYSTEM DATA PROGRAMMING
ISDN-BRI Programming
• When providing Tandem Connection (COT/ODT/LDT/DTI to ISDN, ISDN to COT/ODT/LDT/
DTI), do the following programming:
DESCRIPTION DATA
Specify whether the busy tone is sent to a
calling party of ISDN when a called party
is busy in the tandem connection (ISDN to
COT).
(1)
(2)
407
0 : Available (BT)
1 : Not available (RBT)
Specify the combination of trunk routes
allowing the tandem connection.
•
(1)
(2)
Y=0
XX ZZ
XX: 00-63: Incoming Trunk Route
ZZ: 00-63: Outgoing Trunk Route
0 : Allowed
1: Restricted
Specify the timing start when making an
ISDN call from a station (PB/DP telephone
D
term
) or Attendant Console for the
Tandem Connection.
•
(1)
(2)
Y=0
57
03-14: 3 sec.-14 sec.
If no data is set, the timing start is not
effective.
NOTE 1: By using CM41 Y=0>57, an ISDN call is available even if “#” is not dialed.
NOTE 2: CM41 Y=0>57 is effective for dialing a called number. When dialing a called party
subaddress, this command is not effective.
CM08
F
CM36
CM41
G