Filter
Top Products
CHAPTER 3 SYSTEM DATA PROGRAMMING
ISDN-BRI Programming
NEAX2000 IVS
2
ISDN System Manual
ND-70919 (E), Issue 1.0
Page 75
ISDN-BRI PROGRAMMING
BRT Assignment
DESCRIPTION DATA
Assign an AP number to the BRT card.
The AP number must match the SENS
switch setting on the BRT card.
•
(1)
(2)
Y=0
04-15, 20-31: AP No.
10: BRT card
Assign the ISDN Protocol Type for DCH
circuit on the BRT card.
•
(1)
(2)
YY=06
04-15, 20-31: AP No. of BRT assigned
by CM05
ISDN Protocol Type
17 : Australia
18 : New Zealand
20 : AT&T (#4, #5 ESS)
21 : NTI (DMS 100, 250)
22 : Australia ETSI
24 : ETSI Standard (Brazil, Columbia,
Indonesia)
25 : ITU-T Standard (Thailand)
27 : USA NI-1
28 : USA NI-2
63 : Not used
Assign ISDN trunk number to each
channel number of BRT.
NOTE: Be sure to assign the trunk
numbers to all circuits (00-03) of
the 2BRTC card, even if only one
PCM digital line is accommodated
to the card.
Set make-busy to the unused
trunk numbers by CME5 Y=1, 2nd
data=0.
•
(1)
(2)
YY=02
XX ZZ
XX: AP No. assigned by CM05
ZZ: Channel No. (00/01: BRTA)
(00-03: 2BRTC)
D000-D255: Trunk No.
Trunk No. already
assigned by CM10 cannot
to be used.
CMAA
CM07
START
CM05
A
INITIAL
DTI INITIAL
INITIAL