Filter
Top Products
NEAX2000 IVS
2
ISDN System Manual
Page 134 ND-70919 (E), Issue 1.0
CHAPTER 3 SYSTEM DATA PROGRAMMING
Event Based CCIS Programming
CCH Data Assignment
DESCRIPTION DATA
Assign an AP number to the CCH card
(PN-SC00).
The AP number must match the SENSE
switch setting on the CCH card.
•
(1)
(2)
Y=0
04-15, 20-31: AP No.
11: CCH Card
Assign a CCH channel number to each
CCH card.
•
(1)
(2)
YY=07
0-7: CCH channel No.
04-15, 20-31: AP No. of CCH Card
Assign the trunk number used as the
common signaling channel.
•
(1)
(2)
YY=00
0-7: CCH channel No.
000-255: Trunk No. assigned by CM07
Assign an Originating Point Code (OPC) of
own office and Destination Point Code
(DPC) of opposite office, to each CCH
channel.
NOTE: The OPC is used to designate an
originating office in the No. 7 CCIS
network. A single OPC of own
office should be assigned to all
CCH channels provided in the
same system.
•
(1)
(2)
•
(1)
(2)
YY=01
0-7: CCH channel No.
00001-16367: OPC
YY=02
0-7: CCH channel No.
00001-16367: DPC
Assign ACM signal waiting timer. •
(1)
(2)
YY=10
0-7: CCH channel No.
14: 28 sec.
Assign CCH channel to which a signaling
message is transferred according to the
Destination Point Code (DPC) received.
(1)
(2)
00001-16367: DPC
0-7: CCH channel No.
CM06
START
CM05
CMA8
END
CMA7
INITIAL
INITIAL