Filter
Top Products
CHAPTER 4 CIRCUIT CARD INFORMATION
PN-SC01 (DCH)
NEAX2000 IVS
2
ISDN System Manual
ND-70919 (E), Issue 1.0
Page 179
The figure in the SWITCH NAME column and the position in in the SETTING POSITION
column indicate the standard setting of the switch. When the switch is not set as shown by the
figure and , the setting of the switch varies with the system concerned.
NOTE 1: Set the groove on the switch to the desired position.
NOTE 2: When the power is on, flip the MB switch to ON (UP position) before plugging/
unplugging the circuit card.
SW1 (DIP SW)
1 Always set to OFF.
2 Always set to OFF.
3 Always set to OFF.
4 Always set to OFF.
5 Always set to OFF.
6 Always set to OFF.
7 Always set to OFF.
8 Always set to OFF.
SWITCH
NAME
SWITCH
NUMBER
SETTING
POSITION
FUNCTION CHECK
1
2
3
4
5
6
7
8
ON
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF