Filter
Top Products
NEAX2000 IVS
2
ISDN System Manual
Page 50 ND-70919 (E), Issue 1.0
CHAPTER 2 INSTALLATION
Installation Procedure for ISDN-BRI
Mounting BRT Card
(1) Before mounting the BRT (PN-BRTA/2BRTC) card, set the MB switch to
UP position, and set the other switches to appropriate position.
See CHAPTER 4.
(2) Mount the BRT card in the following AP slots on PIM0-PIM7:
PIM0-7: AP00-AP11
The AP11 slot on PIM0 is available only when the FP card is not mounted in the FP11 slot
on PIM0.
NOTE: The BRT card (BRT0/BRT1), which sends a clock signal to PLO of the MP card, must
be mounted in the AP slots on PIM0.
(3) After mounting the card, set the MB switch to DOWN position to put the card in service.
ATTENTION
Contents
Static Sensitive
Handling
Precautions Required