Filter
Top Products
NEAX2000 IVS
2
ISDN System Manual
Page 82 ND-70919 (E), Issue 1.0
CHAPTER 3 SYSTEM DATA PROGRAMMING
ISDN Feature Programming
ISDN FEATURE PROGRAMMING
• Calling Party Recognition Service (Direct-In Termination (DIT))
Refer to “Direct Inward Termination (DIT)” in the Feature Programming Manual.
• DID Addressing (See Page 83.)
•MEGACOM
®
Access
[North America Only]
(See Page 85.)
•MEGACOM
®
800 Service
[North America Only]
Refer to “DID Addressing” for programming instructions. (See Page 83.)
• SID to Network-Present
[Australia/Other Countries]
(See Page 86.)
• CPN to Network-Present
[North America]
(See Page 86.)
• SID to Terminating User-Display
[Australia/Other Countries]
No programming is required.
• CPN to Terminating User-Display
[North America]
No programming is required.
• Subaddress-Present (See Page 89.)
• Trunk Provisioning Service Selection (See Page 90.)
• ISDN PRI Call By Call Service Selection
[North America Only]
(See Page 91.)
• Advice of Charge (AOC)
[Australia/France Only]
(See Page 97.)
• Centrex SHF over ISDN
[N.Z. Only]
(See Page 98.)