Filter
Top Products
NEAX2000 IVS
2
ISDN System Manual
Page 64 ND-70919 (E), Issue 1.0
CHAPTER 3 SYSTEM DATA PROGRAMMING
How to Read This Chapter
HOW TO READ THIS CHAPTER
In the programming procedure, the meaning of (1), (2), and markings are as follows:
(1) : 1st Data
(2) : 2nd Data
: Initial Data
With the system data clear command (CM00, CM01), the data with this marking is
automatically assigned for each command.
: System Initialization
A reset of the MP card is required after data setting.
Press SW1 switch on the MP card.
: DTI Initialization
A reset of the DTI/PRT card is required after data setting.
Set the Make Busy switch to UP and then Down.
: DCH Initialization
A reset of the DCH card is required after data setting.
Set the Make Busy switch to UP and then Down.
INITIAL
DTI INITIAL
DCH INITIAL