CHAPTER 3 SYSTEM DATA PROGRAMMING
ISDN-PRI Programming
NEAX2000 IVS
2
ISDN System Manual
ND-70919 (E), Issue 1.0
Page 73
D Channel Handler Assignment
DESCRIPTION DATA
When you use the DCH card (PN-SC01),
assign an AP number to the DCH card.
The AP number must match the SENS
switch settings on the DCH card.
When you use the PRT card, skip this
assignment.
•
(1)
(2)
Y=0
04-15, 20-31: AP No.
12: DCH card
Select DCH for ISDN-PRI. •
(1)
(2)
YY=14
04-15, 20-31: AP No. assigned by
CM05
0 : PN-24PRTA (Built-in DCH)
1 : PN-SC01 (DCH)
Assign the ISDN Protocol Type for DCH/
PRT card.
•
(1)
(2)
YY=06
04-15, 20-31: AP No. of DCH/PRT card
assigned by CM05
ISDN Protocol Type
17 : Australia
18 : New Zealand
19 : ITU-T (Hong Kong)
20 : AT&T (#4, #5 ESS)
21 : NTI (DMS 100, 250)
22 : Australia ETSI
23 : ETSI VN4 (Chile)
24 : ETSI Standard (Brazil, Chile,
Columbia)
25 : ITU-T Standard (Thailand)
28 : USA NI-2
63 : Not used
Assign the DCH number to the AP number
of DCH/PRT card assigned by CM05.
•
(1)
(2)
YY=08
0-7: DCH No.
04-15, 20-31: AP No. of DCH/PRT card
assigned by CM05
Assign the DCH number to the each B
channel trunk route assigned by CM30
YY=00.
•
(1)
(2)
YY=93
Assignment of D Channel Handler
00-63: B channel Trunk Route No.
00-07: DCH No. assigned by CM06
CMAA
CM06
CM35
START
CM05
A
INITIAL
DTI INITIAL
INITIAL