Filter
Top Products
NEAX2000 IVS
2
ISDN System Manual
Page 66 ND-70919 (E), Issue 1.0
CHAPTER 3 SYSTEM DATA PROGRAMMING
ISDN-PRI Programming
DESCRIPTION DATA
Assign the necessary functions to the DTI/
PRT card. CMAA YY=00/01/02 assign-
ment is required only for 24DTI/PRT.
After entering the data, set the MB switch
on the DTI/PRT card to UP, and then to
DOWN, for DTI/PRT initialization.
NOTE: The following table shows the
relationship between CMAA
YY=01 and YY=02.
•
(1)
(2)
•
(1)
(2)
•
(1)
(2)
•
(1)
(2)
YY=00 Data Mode
04-15, 20-31: AP No. assigned by
CM05
0: Based on AT&T Spec.
YY=01 Frame Configuration
04-15, 20-31: AP No. assigned by
CM05
0 : 12-Multi Frame
1 : 24-Multi Frame
YY=02 Zero Code Suppression
04-15, 20-31: AP No. assigned by
CM05
0 : Available
1 : Not available
YY=03
04-15, 20-31: AP No. assigned by
CM05
7 : Associated Channel
Interoffice Signaling
Assign a trunk route number to each ISDN
trunk used for voice channel and also to
signaling channel. The DTI route must be
separated from any analog trunk route.
•
(1)
(2)
YY=00
000-255: Trunk No. assigned by CM07
YY=01
00-63: Trunk Route No.
Assign the trunk route data to each ISDN
incoming trunk used for Voice channel
only.
•
•
•
•
(1)
(2)
YY=02 Day Mode
YY=03 Night Mode
YY=40 Mode A
YY=41 Mode B
000-255: Trunk No. assigned by CM07
YY=01
02: Trunk Line Appearance
03: Trunk Line Appearance + TAS
04: Direct-In Termination
09: Automated Attendant
14: Termination to Attendant console
16: Remote Access to System (DISA)
18: ISDN Indial
CMAA
A
CM30
B
DTI INITIAL
[ ]: Indicates 2nd data
CMAA YY=01
(FRAME CON-
FIGURATION)
CMAA YY=02
(ZERO CODE
SUPPRES-
SION)
SIGNALING
24-Multi Frame
[1]
B8ZS
12-Multi Frame
[0]
Not available [1] Transparent
Available [0] B7