Filter
Top Products
NEAX2000 IVS
2
ISDN System Manual
Page 124 ND-70919 (E), Issue 1.0
CHAPTER 3 SYSTEM DATA PROGRAMMING
Event Based CCIS Programming
Mate-Side Trunk Programming
DESCRIPTION DATA
Assign a trunk number to each channel on
the Mate-Side trunk.
NOTE: The Virtual channel number on
the Mate-Side Trunk must be an
odd number (01, 03, 05, ... 31).
•
(1)
(2)
YY=05
3201-3231: Virtual channel No. 01-31
(Odd No.) of the Mate-Side
Trunk
D000-D255: Trunk No.
Assign a trunk route number to each trunk. •
(1)
(2)
YY=00
000-255: Trunk No.
00-63: Trunk Route No.
Assign a trunk number, of the opposite
office, sent to the network on Event Based
CCIS connection. The trunk number is
sent by the subaddress to activate the
relation between the trunks used for Event
Based CCIS.
NOTE 1: CM30 YY=19 is not required
when the trunk number is sent
by ISDN Indial dialed-in digits.
(CM35 YYY=143>1)
NOTE 2: CM30 YY=19 must be an
unique combination between
the offices.
•
(1)
(2)
YY=19
000-255: Trunk No.
X-XXXX: Trunk No. of the opposite of-
fice
Assign trunk route data to the voice
channels and common signaling channel
of the Event Based CCIS route, as Tie
Lines.
•
(1)
(2)
YY=00
00-63: Trunk Route No.
04: Tie Line
Assign the abbreviated codes for
terminating number of the opposite office.
The terminating number and its memory
allocation should be assigned by CM71,
CM72.
•
(1)
(2)
YY=40
00-63: Trunk Route No.
00-31: Abbreviated Codes
CM30
START
CM07
A
CM35
INITIAL