Filter
Top Products
NEAX2000 IVS
2
ISDN System Manual
Page 42 ND-70919 (E), Issue 1.0
CHAPTER 2 INSTALLATION
Installation Procedure for ISDN-PRI
Mounting DTI and DCH Card/PRT Card
(1) Before mounting the 24DTI (PN-24DTA-C)/PRT (PN-24PRTA)/30DTI
(PN-30DTC-A) card and DCH (PN-SC01) card, set the MB switch to UP
position, and set the other switches to appropriate position.
See CHAPTER 4.
(2) Mount the 24DTI/30DTI/PRT card and the DCH card in the following AP
slots on PIM0-PIM7:
PIM 0-7: AP00-AP11
The AP11 slot on PIM0 is available only when the FP card is not mounted in the FP11 slot
on PIM0.
If you use the PRT card, the DCH card is not required because the PRT has a built-in DCH.
NOTE: The DTI/PRT card (DTI/PRT0, DTI/PRT1) which sends a clock signal to PLO of the MP
card must be mounted in the AP slots on PIM0.
After mounting the card, set the MB switch to DOWN position to put the card in service.
ATTENTION
Contents
Static Sensitive
Handling
Precautions Required