Filter
Top Products
7400B and 7400B Plus Data Module
SW1-4 (Not used)
SW1-5 Data Metering Option
When this switch is set to ON, the data module and associated terminal can operate at
higher speeds than the far-end data point. This switch is usually set to OFF.
SW1-6 Suppress Touch-Tone/Dial Tone (for 7400B Plus)
Leave this switch set to OFF if the user prefers listening to Touch-Tones as voice calls
are being dialed. Set the switch to ON if the user wants to suppress Touch-Tones. If the
user is using a speakerphone, ringing will be heard after the call has been made.
SW1-7 Speakerphone Enable/Disable Option (for 7400B Plus)
Leave this switch set to OFF if the user wants the speakerphone to turn on automatically
when the terminal is used to make a voice call. Set the switch to ON if there is no speak-
erphone or if the user wants to disable the speakerphone automatic activation feature.
SW1-8 Make Busy on Local Loop Option
This switch should be set to ON if the user wants the telephone line to appear busy when
the local loopback test feature is used to check the interface between the data module
and the terminal.
Notes for Use with PC Packages
The 7400B Plus voice and data feature has been tested with the following PC communication
packages:
CARBON COPY Plus V5.1
Crosstalk XVI V3.71
Crosstalk Mk.4 V1.1
Hot Line V2.2 (voice dialing packages)
HyperACCESS V3.32
MicroPhone V1.5 (MacIntosh package)
PC TOOLS Deluxe V6 (voice dialing packages)
Procomm Plus V1.1B
Relay Gold V3.0
SideKick V1.5 and SideKick Plus (voice dialing packages)
Smartcom II V2.2
Smartcom II V3.1
Smartcom III V1.1
Smarterm 240 V3.0a
5-15