Filter
Top Products
MDW 9000 Wireless Telephone
Outside Line or Intercom/ Programmable Feature Buttons
When labeled with an extension number, these buttons indicate lines used for incoming and out-
going calls (call appearances) and for using the telephone as an intercom; when programmed
and labeled with feature names, these buttons access features (feature buttons).
MUTE button
The MUTE button is used to turn on and off the microphone associated with the handset
or
the
headset.
Headset On/Off Button
This button is used for turning the headset on and off. Located on top of the handset, it is used
when the headset jack is in use. At all other times, the Headset On/Off button is deactivated to
prevent accidental call termination.
Handset (and Headset) ON/OFF Button
This On/Off button is used for turning the handset on and off. (It can also be used to turn the
headset on or off.)
LCD Display
The display provides information on the status of lines and range, battery power, mute usage,
etc. (See ‘‘Display Information’’ later in this section.)
Dial Pad
This is the standard 12-button pad for dialing telephone numbers and accessing features.
Volume Control Switch
The Volume control adjusts the receiver volume (higher or lower) when the handset is off-hook
and adjusts the ring volume (higher or lower) when the handset is on-hook.
Antenna
The antenna is used for receiving the transmissions from the radio module. This antenna is flexi-
ble and is permanently attached to the handset.
3-477