Filter
Top Products
MDC 9000 Cordless Telephone
Switch Administration
Aliasing
For all System 75, System 85, DEFINITY Generic 1, Generic 2, and Generic 3, Versions 1 and 2,
the MDC 9000 terminal must be administered as a 7303S Hybrid terminal.
Beginning with DEFINITY Generic 3, Version 3 (or later), the MDC 9000 can be administered as
itself.
For the System 85, R2V1 through R2V4 switch which does not accommodate Universal modules,
an ANN17B Hybrid pack in conjunction with a DS-1 carrier must be used to connect the switch
and the MDC 9000 terminal. On all other switches, including System 75, DEFINITY Generic 1,
Generic 2, and Generic 3, a TN62B Hybrid pack must be used with the Universal carrier for this
purpose.
Note: A DEFINITY Generic 2 may use either an ANN17B or a TN62B pack. In either case,
the latest vintage packs are recommended.
Button Numbering
Only the system manager should administer feature button assignments on the telephone. It is
recommended that you not use a feature that requires visuals (that is, the light next to each
administrable button) to be updated while the set is turned off, or any feature that may be
activated by button depression while the set is turned off (for example, Send All Calls).
Use Figure 3 for button numbering on the MDC 9000 set when it is connected to a System 75 or
DEFINITY Generic 1 or Generic 3 switch. Use Figure 4 for button numbering on the MDC 9000
set when it is connected to a System 85 or DEFINITY Generic 2 switch.
Note: On System 75 and DEFINITY Generic 1 and 3 switches, button numbering begins
with ‘‘1,’’ the button on the upper right of the display. On System 85 and DEFINITY
Generic 2, button numbering starts with ‘‘3.’’
3-467