Filter
Top Products
ISDN 8510T Voice/Data Terminal
Switch Administration
An 8510T voice terminal connected to a DEFINITY G2 should be aliased as a 7507 voice
terminal.
An 8510T voice terminal connected to a DEFINITY G3 can be administered as itself.
An 8510T data terminal connected to a DEFINITY G2 or G3 should be aliased as a 7507
with data.
Button Numbering
When the terminal is connected to a DEFINITY G3, the 10 call appearance/feature but-
tons should be administered as ‘‘BUTTON ASSIGNMENTS’’ 1 through 10. The Normal
feature (the Exit button) should be administered on Button #11.
When the terminal is connected to a DEFINITY G2, the 10 call appearance/feature but-
tons should be administered as ‘‘BUTTON ASSIGNMENTS’’ 3 through 12. The Normal
feature (the Exit button) should be administered on Button #13.
The Service Profiler ID (SPID)
When ISDN terminals are initially installed, a unique SPID number must be entered into the ter-
minal. This number identifies the terminal to the network. Usually, the system manager provides
the SPID for each terminal in the system. Use the following procedure for entering the SPID in
an ISDN 8510T terminal.
1. Press
Menu and then press
Mute .
2. Dial the numbers, ‘‘43’’ (ID).
3. Press
* on the dial pad.
4. Enter digits from the dial pad for a new SPID number. If, at any point, you make a mis-
take, press
* to erase the number and re-enter the SPID.
5. When the SPID number is correct, press
# on the dial pad to save the new SPID in
the terminal.
3-427