Filter
Top Products
ISDN 8510T Voice/Data Terminal
Jacks
The 8510T voice/data terminal housing contains three jacks. The Handset cord jack, for connect-
ing the handset to the terminal, is located on the bottom of the housing, near the front of the ter-
minal. The Line jack, for connecting the line cord to the terminal, is located on the bottom (left
center) of the terminal. The Adjunct jack, which is located on the bottom of the voice terminal
directly below the Line jack, is used for connecting optional adjunct equipment such as an S201A
Speakerphone or a 500A Headset Adapter to the terminal.
Note: When an ADB (board) is installed in the 8510T terminal for data operations, the
RS232 jack is visible on the rear of the set for connecting data equipment. When a
TMI board is installed in the 8510T, two jacks are visible on the rear of the set: the
RS232 for the data connection and an 8-pin round connector for connection of a
video cable.
Cords
Two cords are supplied with the 8510T: a coiled 9-foot modular Handset cord and a 7-foot Line
cord. An optional 12-foot Handset cord is available.
ADB and TMI Boards
An Asynchronous Data Board (ADB) can be installed in the 8510T for data applications. A TMI
(Telephone Multimedia Interface) board can be installed if the 8510T is to be used as a video ter-
minal.
Mounting Options
The 8510T comes equipped with a desk stand. However, the desk stand can be removed, and
the terminal can be mounted on the wall. If you choose to wall-mount the voice terminal, use the
instructions included in the 8510T Voice Terminal Wall Mounting Kit (Comcode: 106614894).
Color
The 8510T is available in AT&T black or AT&T white.
3-423