Filter
Top Products
5
A)
Remove the plastic cover from the phone.
Label the button sheet to show lines and
button features, then place the button sheet
on the phone so the holes fit over the buttons.
Carefully replace the plastic cover.
B)
Make sure the swivel display is set to the lowest
position.
Connecting and Testing Telephones
1
To connect a phone, plug the modular telephone
cord into a modular wall jack or directly into a 206
module extension jack. (If you are connecting a
standard phone and its telephone cord is loose, try
an AT&T D2R mounting cord instead.)
To install two phones (or other devices) on a single
extension jack, see “Combination Extensions” earlier
in this appendix.
2 A)
B)
C)
Test the telephone for proper operation—to test
the power and lights on a system phone,
press and hold the [
# ] button for five seconds.
Before releasing the [
# ] button, lift the handset.
All lights should light, the ringer should sound,
and, on the PARTNER-18D phone, a test
pattern should appear on the display. (If not,
call the support telephone number as
instructed on the inside front cover.)
Replace the handset; the phone is now in normal
operating mode.
Installation
C-15