Filter
Top Products
Wall Mounting
Wall mounting instructions apply only to PARTNER-
model phones. To wall mount an MDC 9000 cordless
phone, follow the instructions in the booklet provided with
the phone.
1
2
3
4
A)
Reverse the plastic hook that sits in the
earpiece part of the handset cradle.
B)
Turn the phone upside down and remove the
tray that holds the User Instruction cards:
press the tabs on both sides of the tray near
the pull out tab while you slide the tray straight
out.
Holding the stand with the wide edge down,
mount the stand on the wall plate using the
keyholes on the base of the stand. For proper
mounting, the wall plate must be an AT&T 630B
connecting block.
A)
B)
C)
A)
To
LINE
B)
C-14 Installation
Plug one end of the telephone cord into
the jack in the center of the wall plate.
Plug the other end of the telephone cord into
the LINE jack on the bottom of the telephone.
Wrap any excess cord around the cord wrap
posts on the bottom inside of the stand.
To mount the phone on the stand, insert the
tabs on the top of the stand into the first set of
notches on the top edge of the phone.
Make sure the telepone cord is neatly wrapped
inside the phone, then rotate the phone down
until the bottom edge snaps into position.
Jack