Filter
Top Products
7-10 Issue 2 December 1995
NEAX 2400 Switch Administration
Configuring the Message Center
Interface Link
Voice messaging information travels from the switch to the SID through the
Message Center Interface (MCI) link. For the MCI link to function properly, you
must configure the MCI data link. During the process you perform the following
actions:
■ Administer the Message Waiting Lamp
■ Assign a port for the MCI link
■ Define the MCI port as a terminal
Administer the Message Waiting Lamp
You must administer the switch to assign Message Waiting Lamp (MWL) control
to the MCI link. Use the following instructions to administer the MCI link MWL
parameters.
NOTE:
Do not change any information on any screen until you contact your NEAX
2400 switch administrator. Few switches are identically configured. The
instructions in this section provide the minimum requirements for the MCI
integration to function with the SID. If you need more information on
configuring the switch, contact your switch administrator or consult the
documentation supplied with the switch.