Filter
Top Products
Remote Annex 6300 Hardware Installation Guide
Chapter 1 Introduction
1-10
Rear Panel Components
PRI ISDN
Interface Port
The PRI ISDN Interface port comes with an 8-pin, RJ48C port for
attaching the PRI ISDN Interface cable connector. The PRI ISDN
Interface provides access to a digital PRI ISDN line.
Ethernet Ports
The Remote Annex 6300 comes with auto-sensed 10Base2, 10Base5,
and 10BaseT Ethernet connectors. Connect to your LAN using one of
the following:
❑ 10Base2 (Thin Ethernet) Ethernet port with a BNC connector.
❑ 10Base5 (Thick Ethernet) Ethernet transceiver port with a
DB15 connector.
❑ 10BaseT (Twisted Pair Ethernet) Ethernet port with an
RJ-45 connector.
A Link Indicator LED is provided. This LED is green when an active
10BaseT segment is attached.
Connect only one interface at a time.
The Remote Annex 6300 must be reset (hard reset) when
changing network interface connections.
Console Port
The Remote Annex 6300 has a 9600-baud console port with an
8-pin, modular jack for attaching the console. The console port
provides access to the ROM Monitor commands when the Remote
Annex 6300 is in test mode and provides access to the console
commands when the unit is running.
Power Switch
The Power switch disconnects AC power without disconnecting the
Remote Annex 6300 from the power source.