Filter
Top Products
Remote Annex 6300 Hardware Installation Guide
Chapter 3 ROM Monitor Commands
3-16
erase
The erase command erases the contents of non-volatile memory,
including the Remote Annex 6300’s Internet address. This command
also restores the parameters to their factory defaults. The syntax is:
erase
If the self-boot option is installed, the erase command prompts for
the non-volatile memory to erase: EEPROM or FLASH. Entering 1 at
the prompt causes the Remote Annex to erase the EEPROM memory
(configuration information); entering 2 at the prompt causes the
Remote Annex to erase the Flash memory (self-boot image).
The erase command does not erase the Ethernet address.
Since the erase command erases the IP address, you must use
the addr command to re-enter the Remote Annex’s IP address
before reloading any software.
The erase command display looks like this:
WARNING
monitor:: erase
1) EEPROM (i.e. Configuration information)
2) FLASH (i.e. Self boot image)
Enter 1 or 2:: 1
Erase all non-volatile EEPROM memory? (y/n) [n]:: y
Erasing 65504 bytes of non-volatile memory. Please
wait...
16K->|Data 0x0
...............................................
Initialized checksum record installed
.
.
.