Filter
Top Products
Remote Annex 6300 Hardware Installation Guide
Chapter 3 ROM Monitor Commands
3-2
Default or current values for parameters are displayed in brackets.
For example:
Enter broadcast address [132.245.6.255]:
At the prompt, enter a different value, or press to leave the
displayed value unchanged.
You can use unique abbreviations for all ROM Monitor commands
except erase. For example, enter boot as bo, and enter net as n. If you
enter an abbreviation that is not unique, an error message describing
the command as ambiguous is displayed on the console terminal.
Command Descriptions
Table 3-1 lists the ROM Monitor commands; the following subsections
describe them.
Table 3-1. ROM Monitor Commands
(continued on next page)
Retur
n
Command Description Use
addr [-d] Displays and sets
EEPROM values
relevant to IP network
addressing, including
the unit’s IP address.
Changing IP
configuration
parameters.
boot [-v] [<file>] Manually boots and
loads the unit’s
operating code.
Changing the address of
the boot image.