Filter
Top Products
Remote Annex 6300 Hardware Installation Guide
Chapter 1 Introduction
1-8
Table 1-2. Network/Status Alarms (continued)
Reset Button
The button is used to:
❑ Enter Setup Mode.
When the button is pressed (ON), the SETUP LED is
green and the Remote Annex 6300 enters Setup mode. In this
mode, configuration data is entered via the Console Terminal
prior to booting the operational software.
❑ Reset the Remote Annex 6300.
When the button is pressed and held for 3 seconds,
the SETUP LED flashes and the Remote Annex 6300 begins
to execute its power-up diagnostics. If the button is
depressed again within 5 to 10 seconds, the Remote Annex
6300 enters Setup mode and waits for configuration
information to be entered.
Alarm Description
LOS RED LOS LED is ON when the PRI interface is detecting no
signal (pulses) on the network interface receiver. When a LOS
condition exists, the PRI interface transmits unframed all ones
(AIS) to the network.
ATTN The ATTN (Attention) LED is amber and ON when the Remote
Annex 6300 requires operator attention. The LED is flashing
when there is a problem.
STAT The STAT (Status) LED is green and ON after the Remote Annex
6300 passes the core power-up diagnostics. The LED flashes after
resetting the Remote Annex 6300.
TRAF The TRAF (Traffic) LED is green and flashing when the Remote
Annex 6300 successfully transmits or receives data from the
LAN.
SETUP
The SETUP LED is green when the button is pressed ON
(Setup mode) and flashing when the button is pressed ON
for 3 seconds (Reset Mode).
Reset
Reset
Reset
Reset
Reset
Reset