3-15Remote Annex 6300 Hardware Installation Guide
Chapter 3 ROM Monitor Commands
To provide remote access to the Remote Annex 6300 ROMs:
1 From a site local to the Remote Annex 6300:
❑ Put the Remote Annex in test mode so the monitor
prompt appears on the console.
❑ Set the modem to auto-answer mode.
2 From the Remote Annex 6300 console port:
❑ At the monitor prompt, enter console-baud.
❑ At the Select Baud Rate prompt, enter the appropriate
baud rate or auto.
❑ Connect the modem to the Remote Annex’s console port.
3 From the remote site:
❑ Dial into the modem connected to the Remote Annex.
❑ Press the key until the monitor prompt appears.
Retur
n