Filter
Top Products
Remote Annex 6300 Hardware Installation Guide
Chapter 3 ROM Monitor Commands
3-28
sequence
The sequence command edits the load/dump interface list. This list
determines the order of the network interfaces the Remote Annex
6300 will use for loading and dumping. The default, net, uses the LAN
interface. If the Remote Annex 6300 fails to boot using the first
interface, it will try the next interface. The command syntax is:
sequence [–d] | [interface[,interface]. . .]
Specify the LAN interface by selecting net. Separate each interface
with a comma or a space. Enter the interface list as an argument to
the command, otherwise the console displays a list of available
interfaces and prompts for a new list.
In the following example, interfaces are assigned to the load/dump
sequence list.
Thesequence –d command displays the current load/dump interface
list. You cannot specify both the –d argument and the interface list
with the same command. The command display looks like this:
monitor:: sequence
Enter a list of 1 to 4 interfaces to attempt to use for
downloading code or upline dumping. Enter them in the order
they should be tried, separated by commas or spaces.
Possible interfaces are:
Ethernet:net
SELF: self
Enter interface sequence [net]:: self, net
Interface sequence: self,net
monitor:: sequence –d
Interface sequence: self,net