Nortel Networks 6300 Telephone User Manual


 
3-13Remote Annex 6300 Hardware Installation Guide
Chapter 3 ROM Monitor Commands
config
The configcommand displays the current configuration information
and revision levels for the Remote Annex 6300. The config command
displays revision information, the amount of memory installed, T1 or
E1 configuration information, and a description of the number and
type of modems installed. The command syntax is:
config
The config command display for a Remote Annex 6300 with 24
modems (T1) looks similar to this:
This display is typical for T1 versions. For E1 versions,
information on 32 ports will be shown. For modem-less
versions, no port or modem information will be shown.
REVISION/CONFIGURATION INFORMATION
ROM Software Rev: 1002
Board ID: 63 Board Type: RA6300
CPU Type: 486DX2 Ethernet Address: 00-80-2D-02-CE-A9
Memory size: 8 Meg EEPROM size: 65504
Flash size: 2 Meg Flash ID: 8989
Available Interfaces ( *= selected) ThickNet ThinNet *Twisted Pair
SLC Local DRAM Size: 4 Meg SLC SRAM Size: 128 K
TDM Interface: PRI T1 USA Revision: VERSION A MGR=1.117
Modem Country Code : 63
Port # 1 2 3 4 5 6 7 8 9 10 11 12
Modem ID 2883 2883 2883 2883 2883 2883 2883 2883 2883 2883 2883 2883
Mod Status OK OK OK OK OK OK OK OK OK OK OK OK
Port # 13 14 15 16 17 18 19 20 21 22 23 24
Modem ID 2883 2883 2883 2883 2883 2883 2883 2883 2883 2883 2883 2883
Mod Status OK OK OK OK OK OK OK OK OK OK OK OK