Nortel Networks 6300 Telephone User Manual


 
Remote Annex 6300 Hardware Installation Guide
Appendix C Modem Carrier Card Upgrade Instructions
C-6
Power-up and Test
To run the Remote Annex 6300 power-up and test sequence:
1 Reconnect all the cables, including:
The Ethernet cable
The PRI ISDN Interface cable
The console terminal cable
The power cord
2 Turn on the unit’s power.
3 Set the Remote Annex 6300 to Test mode by pressing and holding
the button (located on the front panel) for three seconds
(see
Figure C-4).
The Remote Annex runs its ROM-resident power-up diagnostics.
Figure C-4. Setting the Remote Annex 6300 to Test Mode
Reset
Reset
Button
Bay Networks
Remote Annex 6300
Xylogics,
a Bay Networks Company
32 31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16 15
Modem Status
1413121110987654321
CD
Tx/Rx
13-169-12 5-8 1-4
29-3225-2821-2417-20
Modem Config
Status
TestSync Los
Red Yel Blu
Stat Traf
Setup
Reset
Power
Attn
Network/Status
Ararms
3231302928272625242322212019181716151413121110987654321
PRI Channel Status