Filter
Top Products
3-19Remote Annex 6300 Hardware Installation Guide
Chapter 3 ROM Monitor Commands
image
The image command sets and displays the name of the image file
containing the Remote Annex 6300’s software. The syntax is:
image [–d | filename]
The filename argument permits up to 100 characters. To return the
image name to its default, enter a pair of double-quote characters ("").
The default image name is oper.63.enet. The image command display
looks like this:
The image –d command display looks like this:
The SELF image name appears only if the self-boot image is
loaded.
If the image file name contains more than 16 characters, it is
truncated when MOP is attempted.
monitor:: image
Enter Image name: [(ip)"oper.63.enet", \
(mop) "OPER_63_ENET.SYS"]::
Enter TFTP Load Directory [""]::
Enter TFTP Dump path/filename ["dump.192.9.200.88"]::
monitor:: image –d
Image name:Default (ip): "oper.63.enet"
Default (mop):"OPER_63_ENET.SYS"
TFTP Load Directory: ""
TFTP Dump path/filename: "dump.192.9.200.88"
SELF image name: "oper.63.enet"