Filter
Top Products
Dolphin® 9500 Series User’s Guide Rev C 5 - 13
Remove Programs
The Remove Programs settings enables you to remove programs installed on the terminal. Use this setting to troubleshoot when
you receive messages that the device is out of memory. The programs removed are removed from RAM memory. Any program
(usually *.cab or *.dll files) stored in the Autoinstall folder (My Device > IPSM > Autoinstall) will re-install after the next hard reset.
For information about the Autoinstall process, see Let Autoinstall Run on page 2-9.
For information about the hard reset process, see Hard Reset (Cold Boot) on page 2-11.
1. Tap the Remove Programs icon.
2. In the list, select a program and tap Remove. The following message appears:
3. Tap Yes. Wait while the program is removed.
4. Verify that the program no longer appears in the list.
Memory
For more detailed memory information, tap memory of “Adjust memory
allocation.” The Memory system setting opens. For
information about memory settings, see Memory on page 5-8.