Filter
Top Products
14 - 6 Rev C Dolphin® 9500 Series User’s Guide
Using the Wall Mount Kit
Wall mount kits can be purchased separately to secure the ChargeBase to a wall or other vertical surface. For the ChargeBase,
you need to purchase two kits so that you have two mounting brackets, one for each end of the ChargeBase. Each mounting
bracket contains an open slot in the back to accommodate the connector cables.
Each mounting bracket contains an open slot in the back to accommodate the connector cables.
1. Insert the head of each screw into the round end of each of the four screw slots on the bottom panel. Slide each screw
towards the narrow end of the screw slot.
2. Use a washer/nut set on each screw to secure the screw in each slot.
3. Attach the bottom panel to the two mounting brackets.
Screws in the narrow end of each slot
Washer/Nut
Open Slot for Connector Cables
Mounting Brackets