Filter
Top Products
4 - 16 Rev C Dolphin® 9500 Series User’s Guide
1. Open the Radio Manager by tapping Start > Settings > Connections tab > Radio Manager.
The Radio Manager appears identifying the radios and radio combinations that can be enabled on your terminal in the
Radio Modes list. (To appear on this window, a radio’s hardware module must be installed.)
2. Select the radio or radio combination and tap Apply. The Radio Manager begins enabling your radio or radio combination.
3. When enabled, the Status field reads “Success.”
Radio Manager Window
Radio Modes The Radio Modes section displays the radio hardware modules currently installed on the terminal.
Status field The Status field provides feedback on the state of the radio:
To Disable Radios
Radio drivers are automatically powered down if the radio combination that is currently enabled requires it.
To disable all radios, select None in the Radio Modes box and tap Apply.
Ready Selected radio is enabled and the Radio Manager is ready to receive a command.
Success Selected radio was enabled successfully.
Error Message Selected radio could not be enabled.