Filter
Top Products
5-15
Cisco BTS 10200 Softswitch Operations and Maintenance Guide, Release 6.0.x
OL-16000-07
Chapter 5 Managing External Resources
Managing Subscriber Terminations
Any failure • Found no failure, subscriber category invalid, entity unequipped in
initial state, unknown failure reason(s).
• Subscriber(s) cannot be found, subscriber(s) state change and
pending.
• No termination(s) found in MGW.
• Fail while in termination table.
• Administration state invalid, operational state invalid.
• Failed to allocate IPC message(s), failed to dispatch IPC message(s).
• Entity in desired state.
• Not allow subscriber to reset.
• Change to out-of-service state required.
Subscriber
commands
Failure
• The media gateway is down, unreachable, in a faulty state,
transitioning to another state.
• The transaction could not be executed because the endpoint is
unknown, the endpoint is not ready, the endpoint does not have
enough resources available, the endpoint is restarting, the command
contained an unrecognized extension, the gateway is not equipped to
detect one of the requested events, the gateway is not equipped to
generate one of the requested signals, the gateway cannot send the
specified announcement.
• Invalid conn identifier, invalid call ID.
• Unsupported mode or invalid mode, unsupported or unknown
package.
• Endpoint does not have a digit map, endpoint redirected to another
Call Agent, endpoint malfunctioning, endpoint taken out of service.
• No such event or signal.
• Unknown action or illegal combination of actions.
• Internal consistency in local connection options, unknown extensions
in local connection options, unsupported values on local connection
options.
• Insufficient bandwidth.
• Missing remote connection descriptor.
• Incompatible protocol version.
• Response too big.
• Loss of lower connectivity.
• No fault reason available.
Table 5-6 Understanding Subscriber Command Responses (continued)
Command
Entered
Command
Response Possible Conditions