Filter
Top Products
5-29
Cisco BTS 10200 Softswitch Operations and Maintenance Guide, Release 6.0.x
OL-16000-07
Chapter 5 Managing External Resources
Provisioning the GigE Interface
shut
no shut
Step 5 Save the switch configuration.
Step 6 Reboot the Cisco BTS 10200 host using the shutdown -g0 -y -i6 command. We recommend that you
execute the shutdown command using the console port to avoid loss of connectivity during the reboot.
After the reboot, all the targeted Cisco BTS 10200 applications should automatically restart and go into
standby state.
Step 7 Verify interface speed and duplex mode by executing the following command on the host:
dladm show-dev
Example output:
ca102> dladm show-dev
bge0 link: up speed: 1000 Mbps duplex: full
bge1 link: up speed: 1000 Mbps duplex: full
bge2 link: up speed: 1000 Mbps duplex: full
bge3 link: up speed: 1000 Mbps duplex: full
Step 8 Repeat for the other UNIX hosts in the Cisco BTS 10200 system.