5-9
Cisco BTS 10200 Softswitch Operations and Maintenance Guide, Release 6.0.x
OL-16000-07
Chapter 5 Managing External Resources
Managing Trunk Groups and Trunks
Trunk
Termination
commands
Failure • The transaction could not be executed due to a transient error, the
endpoint is unknown, the endpoint is not ready, endpoint does not
have enough resources available, a protocol error was detected, the
command contained an unrecognized extension, the endpoint is
restarting.
• Invalid conn identifier, invalid call ID.
• Unsupported mode or invalid mode, unsupported or unknown
package.
• Endpoint does not have a digit map, endpoint redirected to another
Call Agent, endpoint malfunctioning, endpoint taken out of service.
• No such event or signal.
• Unknown action or illegal combination of actions.
• Internal consistency in local connection options, unknown extensions
in local connection options, unsupported values on local connection
options.
• Insufficient bandwidth.
• Missing remote connection descriptor.
• Incompatible protocol version.
• Internal hardware failure.
• CAS signaling protocol error.
• Failure of a group of trunks.
• Response too big.
• Loss of lower connectivity.
• No fault reason available.
Table 5-4 Understanding Trunk Group and Trunk Generic Command Responses (continued)
Command
Entered
Command
Response Possible Conditions
