MT8850A / MT8852A Bluetooth Test Set Using the Script Menu
4. Choose “Number of packets”.
5. Enter the number of packets using the keypad.
6. Choose “Hopping”.
7. Press the
key to switch between ON and OFF. If you choose ON, choose
Hopping test mode and press the key to switch between All and Any.
8. Choose Test type.
9. Press the
key to switch between Loopback and TX.
10. Press the
[1 of 2] soft key to move to the second screen.
The second screen will vary according to whether the Test type is in Loopback or TX
mode. The following screen is in Loopback mode.
The following screen is in TX mode.
You can select or deselect the test to run and make changes to the frequency values
shown.
11. To select or deselect a test, choose the test and press the
key.
12. To change a frequency, choose the frequency, press the
key, enter the value
using the keypad and press the
[Enter] soft key.
13. Press the
[Defaults] soft key to restore the default values.
14. Press the
[Limits] soft key to display the Initial carrier test limits screen.
8-18 13000-000109
Testing in Standard Script Mode June 2003