Using the Script Menu MT8850A / MT8852A Bluetooth Test Set
Viewing Test Results
The results screens show pass or fail results for test limits set to ON. These screens are
for information only and cannot be changed.
The results screens detailed below apply for each of the script mode settings (standard,
single payload, and null packet) unless otherwise stated.
Output Power Test Results
1. Choose “Output power” from the Script menu.
2. Press the
[Results] soft key.
The Output power results screen is displayed.
Definition of test results
Current Pkt Displays the average power of the last packet measured by the
MT8850A/MT8852A. The MT8850A/MT8852A identifies the p0 in the
packet and measures the power in each individual bit. Packet avg is the
average power of all the measured bits.
Pkt Avg; Max Displays the highest power measured of all of the Packet avg
measurements during the test.
Pkt Avg; Min Displays the lowest power measured of all of the Packet avg
measurements during the test.
Test peak This is the power of the single bit in the packet that has the greatest
power. The value displayed is the largest peak power measured for all
packets in the test.
3. Press the
[Extended] soft key to display more detailed test results. As opposed to
the summary screen shown above, the extended screens are specific to each of the
test scenarios. For example, if a test is performed at high, medium, and low
frequencies, with hopping both on and off, there would be six extended screens. An
example of the first extended screen for the output power test is shown below.
4. Page through the extended screens with the soft key in the normal manner, or press
the [Summary] soft key to revert to the initial summary page.
13000-000109 8-41
June 2003 Viewing Test Results