Filter
Top Products
MT8850A / MT8852A Bluetooth Test Set Installation
Storage and Shipment
The following paragraphs describe preparing the MT8850A/MT8852A Bluetooth Test Set
for storage and shipment.
Preparation For Storage
Preparing the MT8850A/MT8852A Bluetooth Test Set for storage consists of cleaning the
instrument and packing it with moisture-absorbing desiccant crystals.
Environmental Requirements
Store the instrument in a temperature controlled environment that is maintained
between -40 and +70º C (-40 to ±156º F), with a maximum humidity of 90% at 40º C (104º
F), non-condensing.
Preparation for Shipment
To provide maximum protection against damage in transit, the MT8850A/MT8852A
Bluetooth Test Set should be repackaged in the original shipping container. If this
container is no longer available and the MT8850A/MT8852A is being returned to Anritsu
for repair, advise Anritsu Customer Service Center; they will send a new shipping
container free of charge. In the event neither of these two options is possible, follow the
packaging instructions below.
Use a
Suitable
Container
Obtain a corrugated cardboard carton with a 125 Kg (275-pound) test
strength. This carton should have inside dimensions of no less than 150
mm (6 in) larger than the instrument dimensions to allow for cushioning.
Protect the
Instrument
Wrap the instrument to protect the finish.
Cushion the
Instrument
Cushion the instrument on all sides by tightly packing dunnage or
urethane foam between the carton and the instrument. Provide at least
75 mm (3 in) of dunnage on all sides.
Seal the
Container
Seal the carton using either shipping tape or an industrial stapler.
Address the
container
If the instrument is being returned to Anritsu for service, mark the
address of the appropriate Anritsu service center, the Return Materials
Authorization (RMA) number, and your return address on the carton in a
prominent location.
3-10 13000-000109
Storage and Shipment June 2003