Filter
Top Products
MT8850A / MT8852A Bluetooth Test Set Using the Script Menu
3. Press the
[Setup] soft key.
The Output power test conditions screens are displayed.
4. Choose “Hopping”.
5. Press the
key to switch between On, Off & On, and Off. It should be noted
that if hopping is set to “Off”, the “Hopping test mode” setting below is redundant.
6. Choose “Hopping test mode”.
7. Press the key to switch between Defined, All and Any.
8. Choose “No. of packets”.
9. Enter the value using the keypad.
10. Choose Test type.
11. Press the
key to switch between Loopback and TX.
12. Choose “Packet type”.
13. Press the
key repeatedly until the required packet type, Longest, DH1, DH3
or DH5 is displayed. Longest sets the packet type to the longest length that the EUT
supports during the link setup process.
14. Press the
[1 of 2] soft key to move to the second screen.
You can select or deselect the test to run and make changes to the frequency.
When the Hopping test mode is set to All or Any, the Low, Medium and High frequencies
are not applicable and they are displayed as hollow ellipses.
15. To select or deselect a test, choose the test and press the
key.
16. To change a frequency, choose the frequency, press the
key, enter the value
using the keypad and press the
[Enter] soft key.
17. Press the
[Defaults] soft key to restore the default values.
8-12 13000-000109
Testing in Standard Script Mode June 2003