Filter
Top Products
Configuring the MT8850A/MT8852A MT8850A / MT8852A Bluetooth Test Set
Setting Up the EUT Control
The control setup enables you to configure the serial communications that are used to link
the HCI of the equipment under test to the MT8850A/MT8852A tester.
1. Press the
hard key.
2. Choose “Equipment Under Test (EUT)”.
3. Press the
key.
4. Choose “EUT RS232 setup”.
5. Press the
key.
The EUT RS232 setup screen is displayed.
The RS232 baud rate for the MT8850A can be 1200, 2400, 4800, 9600, 19200,
38400, 57600, or 115200 baud but must be the same at both ends. For the
MT8852A, three additional rates are also available; 230400, 460800, and 921600.
•
6. Select the item that you want to change.
7. Repeatedly press the
key until the required value is displayed.
8. Press the
key to exit this screen.
13000-000109 7-5
June 2003 Setting up the EUT