Filter
Top Products
64 - 165 IP Telephony v1.0 Lab 4.1.3 Copyright © 2005, Cisco Systems, Inc.
f. Use the port X/X/X:23 command to apply the dial peer to a specific interface. This command
allows calls that come in from the previously defined numbers (5555xxx) to be allowed through a
particular router port. An example of this command is as follows: port 1/0/0:23 or port 1/0:23
(depending on what model of NM-HDV2-1T1/E1 is being used). Use the port parameters
previously documented in a question.
CMERouterX(config-dial-peer)# port X/X/X:23
g. Test the configuration by calling from the analog phone attached to the Adtran analog (FXS) port
to the analog phone connected to the FXS port on the router.
h. Did the call work properly? If not, perform appropriate troubleshooting. ____________
i. Save the router configuration.